29
Chapter 3 Operation Panel / Digital Operator
3-1 Operation Panel of the Drives
The operator keypad & display contains a 5 digit 7 segment display, 4 control keys
and one Power status LED (Green) is lit when the power is applied to the unit.
Power on to light up charge LED and gradually dark when internal main circuit discharge accomplished.
Do NOT connect or assemble the servo drive before Power LED is off.
Key Name Function Keys Description
MODE
MODE/SET
1. To select a basic mode, such as the status display mode, utility
function mode, parameter setting mode, or monitor mode.
2. Returning back to parameter selection from data-setting screen.
INCREMENT
DECREMENT
1. Parameter Selection.
2. To increase or decrease the set value.
3. Press
and at the same time to RESET ALARM.
ENTER
DATA SETTING
&
DATA ENTER
1. To confirm data and parameter item.
2. To shift to the next digit on the left.
3. To enter the data setting (press 2 sec.)
To Next Page
Loading...
Need help?
General
