Chapter 1: Getting Started 4
Quick Start Setup
This section is a simple guide for connecting, programming and operating your new SG2 smart relay. This is not
intended to be the complete instructions for programming and installation of your system. Refer to other sections in
the manual for more detailed information.
Install SG2 Client Software
Install the SG2 Client Software from CD or from the free internet download at www.teco.com.tw
Connect Power to SG2 smart relay
Connect power to the Smart Relay using the below wiring diagrams for AC or DC supply for the applicable
modules. See “Chapter 2: Installation” for complete wiring and installation instructions.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
To Next Page
Loading...
