Chapter 7 Hardware Specification 201
Inductance Load
There will be a surging voltage (KV) when the inductance load switches between ON and OFF, especially for
the relay model. The methods to different power mode to absorb the surging voltage are shown below.
a. AC power，CR absorbing b. DC power，flywheel diode
Please do can’t use capacitance alone as absorbing as shown below.
Life of relay
※ The data of picture above is standard, but the life of relay is influenced by the temperature of operation
environmental.
※ The life is more than 100K times if the current is less than 2A.
Power mode
Mode Input/Output
DC +12V AC 100~240V / DC +12V
DC +24V AC 100~240V / DC +24V
Accessory
MODE description
PM05
memory cartridge
SG2 Client SG2 program software
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
To Next Page
Loading...
