TECO SG2-12HT-D - Output Specifications; Output Port Wiring Notice; Light Load

Chapter 7 Hardware Specification 200
Output Specifications
content relay transistor
output circuitry
Extern power
Less than AC265，DC30V
23.9~24.1V
circuitry isolation mechanism isolation
Photo couplers isolation
Resistive
8A/point 0.3A/point
Inductive
－ －
Maximal
Load
light 200W 10W/DC 24V
Open drain current
－
<10uA
Minimum Load
－ －
OFF ON 15 ms 25 us Response
time
ON OFF 15 ms Less than 0.6 ms
Output Port wiring notice
Light Load
The surging current will appear at the moment of the lamp is conducting; it may 10~20 times the rated current
for almost 10ms when filament is turning-on. A distributaries resistance or restricted current resistance is added at
output port to reduce the surging problem.
distributaries resistance
There is a little current makes light shine
faintness, so the value of resistance must be
careful.
restricted current resistance
The brightness will not be bright if the
resistance value is too big.
SG2
Load
Extern power
SG2
Load
Extern power
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor