TECO SG2-12HT-D - Mounting

Chapter 2 Installation 16
Mounting
DIN-rail Mounting
The SG2 smart relay should always be mounted vertically. Press the slots on the back of the SG2 and expansion
module plug CONNECTOR onto the rail until the plastic clamps hold the rails in place. Then connect the expansion
module and CONNECTOR with the Master (press the PRESS-BUTTON simultaneously)
SG2-8ER-A
Output 4 x Relay / 8A
Q1 Q2 Q3 Q4
DC 24V Input 8 x DC(A1,A2 0~10V)
SG2-12HR-D
+
-
I1 I2
I4
I3
I5
A1I6 A2
Input
4
× AC
L N
Run
AC 100~240V
X4X1 X2 X3
Output 4 x Relay / 8A
Y1 Y2
Y3 Y4
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor