Chapter 1: Getting Started 6
c. Select the correct Com Port number where the programming cable is connected to the computer then press the
“link” button.
d. The SG2 Client will then begin to detect the connected smart relay to complete its connection.
Write simple program
a. Write a simple one rung program by clicking on the leftmost cell at line 001 of the programming grid, then click
on the “M” contact icon on the ladder toolbar, as shown below. Select M01 and press the OK button.
See “Chapter 4: Ladder Programming instructions” for complete instruction set definitions.
Note: If the ladder toolbar is not visible at the bottom of the screen, select V
iew/Ladder Toolbar from the menu to
enable.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
To Next Page
Loading...
