Chapter 9 Expansion Module 238
Configure
You can use Local area network or Ethernet to configure this module. In the Ethernet this module need to have
the IP address that can visit. You can obtain the IP address through the Network address Translation or The manager
of the Ethernet. In the Local area network, please be sure to follow the procedures given below.
1. Click Start in the Windows Taskbar → Programs → XPortInstaller → XPortInstaller.
2. Click the Search icon
and choose it.
A. Hardware Address
The format: 00-20-4A-XX-XX-XX, where the XXs are unique numbers assigned to the product.
B. IP Address
EN01 must have a unique IP address on your network. The systems administrator generally provides the IP
address, subnet mask, and gateway. The IP address must be within a valid range, unique to your network, and in
the same subnet as your PC. The format: 0.0.0.0 (e.g. 10.128.19.119).
3. Click the Assign IP icon
.
Click the Assign IP icon Enter the IP address Format and click OK
Note: Enter the IP address Format: 0.0.0.0, and click OK.
Waiting for about 10Sec and the window displays in your window, click OK.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
To Next Page
Loading...
