Tecsun PL-310ET - Sleep Function; Clock Setting

1. Press & hold the [TIME] button
until hours flashing, then rotate
the [TUNING] knob to adjust the
hour.
2. Press the [TIME] button, then
rotate the [TUNING] knob to
adjust the minutes while minutes
is flashing.
3. Press the [TIME] button to confirm the setting.
※ If the [TIME] button has not been pressed again within 3
seconds, the unit will automatically confirm the setting.
Note: You can also direct key-in the number to set the
clock after pressing & holding the [TIME] button.
Example: To set the clock to 6:35, press the numeric key
to enter 0 6 3 5 ; then you will hear a prolonged
beep (B) sound suggesting that the time has been set.
Timer
SLEEP
Timer
13
PL-310ET
SLEEP FUNCTION
1.Press & hold the [POWER]
button until “ ” and “On or
1~120” shows on the display.
2.Rotate the [TUNING] knob
immediately to select sleep
timer from 1 ~ 120 minutes or
select permanently “ On ”,
then wait until the radio auto
turn on to confirm the setting.
flashing
Sleep time range
SLEEP
CLOCK SETTING
flashing