SLEEP
Timer
PL-310ET
6
flashing
Frequency
changing
Preset station
number ETM
Press the [POWER] button to turn on your radio, then
select your desired band by pressing the [FM], [MW/LW],
SW [ ] or [ ] button. In case of receiving FM/ SW
broadcasting, fully extend the telescopic antenna for a
better reception. When receiving MW (LW) broadcasting,
please rotate the radio or change it's location to achieve
optimum reception. Now, you can turn into your favorite
stations with any of the below tuning methods:
TUNE INTO STATIONS
METHOD 1:
ETM (EASY TUNING MODE)
ETM is a unique tuning method designed by Tecsun. It
skillfully combines the reception circuitry & control
procedure to pre-select the radio station and temporarily
auto stores them into the ETM memory (not the regular 550
memories). This highly enhances the efficiency when tuning
into radio stations.
1. Press the [ETM] button and “ETM”
will appear on screen to enter Easy
Tuning Mode.
2. Press & hold the [ETM] button until
the frequency start running to auto
scan and store stations into ETM
memory,
within the present band.
3. When the frequency stops
running, turn the [TUNING]
knob to select those stored
stations.
Notes:
While operating ETM to search for stations, a few stations
might be missed if there is interference in the surrounding.
In this case, you can simply key-in the frequency, then press
the [ETM] button to manually store it into the ETM memory.
Please follow below steps to tune into your preferred
frequencies employing ETM:
To Next Page
Loading...
Need help?
General
