10
PL-310ET
1.Press the [VM/VF] button to
switch into frequency mode.
2.Press & hold the [VM/VF] button
with “ “ advancing to auto
browse from one station to
another.
3.While tuning to your desired
station, press the [M] button
followed by “PRESET ” display to
directly store the station into the
next available memory. The
unit will keep on browsing until
you deactivate it by pressing on
the [VM/VF] button again.
METHOD 3: SEMI-AUTO STORING STATIONS
While operating the “Auto Browse Station” function, you can
simply press on the [MEMORY] button to store the station
into memory to avoid storing unwanted stations and
interfering signals.
3.If there is too many interference in your surrounding or
many mirror/blank stations are being stored during ATS,
you should contract the telescopic antenna (FM & SW) or
rotate the radio for better reception (MW & LW).
METHOD 2: STORING STATON MANUALLY
1.Select band and tune to your desired station.
2.Press the [M] button with “PRESET ” flashing.
3.Press the [M] button again to store the station into
memory.
4.You can also wait for 3 seconds to auto store the station
into memory.
SLEEP
Timer
Auto browse station
advancing
To Next Page
Loading...
