WORKING WITH STATION MEMORIES
This device can store 650 stations (presets) into memory: 100 each for FM
and LW, 150 for MW (AM), 300 for SW. You may choose any of the below
methods to store stations.
Storing Stations Manually
1) In VF mode, press the [ FM/ST. ], [ MW/LW ], [ < ] or [ > ] button to select
the frequency band.
2) Tune into the new radio frequency to be stored.
3) Quick press the memory [ M ] button, “PRESET” will flash in the top right
corner of the display to indicate the next available memory location where
the station will be stored. If desired, select a different memory location by
using the [ TUNING ] knob or the numeric keys.
4) Quick press the [ M ] button again to confirm the location or wait for about
2 seconds to automatically store the station into the memory.
Auto Tuning Storage (ATS)
Automatically tune into and store FM, LW, MW and SW stations.
Operation for FM and MW/LW:
1) Quick press [ FM ] or [ MW/LW ] to select the frequency band.
2) Press and hold the [ FM ] or [ MW/LW ] button until “PRESET” flashes and
the frequency starts running.
3) When the frequency stops running, it means the ATS operation has been
completed. The device indicates how many frequencies have been stored
(e.g. 17ch means 17 frequencies were stored). Rotate the [ TUNING ] knob
to view all the stored stations.
8
To Next Page
Loading...
Need help?
General
