Operation for SW:
There are two ATS modes for SW:
Mode A: Press and hold the [ < ] button to initiate ATS within all meter bands.
Mode B: Press and hold the [ > ] button to initiate ATS within the selected
meter band.
Tips:
To stop ATS prematurely, just rotate the tuning knob.
ATS (except in SW mode B) replaces previously stored radio stations. To
prevent this from happening, please consider using ETM+ (see page 12).
ATS results for LW, MW and SW strongly depend on radio wave propagation
conditions, the receiving environment and other factors. If the results are
poor, try to initiate ATS at a different location and/or time, or tune into
stations manually and then store them. For better ATS results in the LW, MW
and SW bands, please also review the tips for ETM+ on page 14.
Storing Stations During Auto Scan
To avoid any unwanted stations that might be stored during Auto Tuning
Storage (ATS), store stations manually during “Auto Scan” (see also page 7).
1) In VF mode, press and hold the [ VF ] button. The device will auto scan
the entire frequency band for available stations. When a station is found it
will stay there for about 5 seconds before continuing the search.
2) Quick press the memory [ M ] button to store a station, the radio will keep
on scanning for the next available station.
3) To stop the auto scan feature, quick press any button (except [ M ]).
9
To Next Page
Loading...
Need help?
General
