10
LISTENING TO STORED STATIONS
Recalling Stored Stations
1) Quick press the [ VM ] button to enter the memory (VM) mode.
2) Select the frequency band of the stored stations that you wish to view.
3) Rotate the [ TUNING ] knob to view the stored stations. Alternatively, use
the numeric keys to enter the memory location directly, and press [ ] to
confirm. If there is no stored station at that location, the display shows
" — — ".
Memory Scan
The device can auto scan all stored stations within a frequency band, staying
on each station for about 5 seconds before continuing.
1) Quick press the [ VM ] button to enter the memory (VM) mode.
2) Select the frequency band for which you wish to view the stored stations.
3) Press and hold the [ VM ] button until “PRESET ” flashes in the upper
right corner of the display. The device starts to scan all stored stations.
To stop scanning quick press any button (except [ ] (DELETE).
Setting a Favorite Station
You can set one favorite station that can be accessed using the [ ]
button on the keypad. Follow these steps to set a favorite station:
1) Select a frequency band.
2) Tune into a frequency.
3) Press and hold the [ ] (favourite) button.
“ “ flashes on the display briefly, your favorite station has been
set. To set a new station as your favorite, follow the above steps again.
To Next Page
Loading...