www.tecsunradios.com.au
10
Storing Stations During Auto Scan
To avoid any unwanted stations that might be stored during Auto Tuning
Storage (ATS), store stations manually during “Auto Scan” (see also page 7).
1) In VF mode, press and hold the [ VF/VM ] button. The device will auto scan
the entire frequency band for available stations. When a station is found it
will stay there for about 5 seconds before continuing the search.
2) Quick press the memory [ M ] button to store a station, the radio will keep
on scanning for the next available station.
3) To stop the auto scan feature, quick press the [ VF / VM ] button.
Recalling Stored Stations
1) Select the frequency band or mode (SYNC/SSB) of the stored stations that
you wish to view.
2) Quick press the [ VF/VM ] button to enter the VM mode.
3) Rotate the [ TUNING ] knob to view the stored stations. Alternatively, use
the numeric keys to enter the memory location directly. If there is no
stored station at that location, the display shows " — — ".
Memory Scan
The device can auto scan all stored stations within a frequency band or mode
(SYNC/SSB), staying on each station for about 5 seconds before continuing.
1) Select the frequency band or mode (SYNC/SSB) for which you wish to
view the stored stations.
2) Quick press the [ VF/VM ] button to enter the VM mode.
3) Press and hold the [ VF/VM ] button until “PRESET ” flashes in the upper
right corner of the display. The device starts to scan all stored stations.
To stop scanning quick press any button (except [ ] (DELETE)).
LISTENING TO STORED STATIONS
To Next Page
Loading...
Need help?
General
