www.tecsunradios.com.au
16
Other Settings and Features
Auto Sorting Memory
This device can automatically organize all stored stations. In power off mode,
press and hold the [ ] (0) button until the station memory preset indicator
on the display starts running. This feature deletes duplicate stations and sorts
the sequence of stored stations from low to high frequency.
Single Sideband (SSB)
When receiving longwave, medium wave (AM) and shortwave signals, you
can activate the SSB mode to receive particular signals like for example
amateur radio communication and Morse Code, but it can also help to
mitigate interference.
Enable/Disable SSB mode: Quick press [ LSB ] (lower sideband) or [ USB ]
(upper sideband) to enable the sideband. Quick press [ SSB ] to disable SSB.
Synchronous Detection (SYNC)
When listening to longwave, medium wave (AM) and shortwave broadcasts,
turning on synchronous detection may reduce noise interference, eliminate
distortion caused by local fading during signal transmission, and suppress
interference caused by adjacent stations (see page 21 for more information).
Enable/Disable SYNC detection:
1) Press and hold [ SSB ] (SYNC), the display shows “ ” and the
radio enters the synchronous detection mode.
2) Quick press [ LSB ] or [ USB ] to select Lower Sideband or Upper
Sideband SYNC detection.
3) To disable, quick press [ SSB ] and “SYNC” disappears from the display.
Note: Enabling the SYNC detector does not always reduce interference.
To Next Page
Loading...
Need help?
General
