www.tecsunradios.com.au
19
Setting the Alarm Time
1 Press and hold [ ALARM ] until the alarm time in the upper right corner of
the display starts flashing.
2) While still flashing, use the numeric keys to enter the time (4 digits in total),
or rotate the [ TUNING ] knob to adjust the hour and the [ VOLUME ] knob
to adjust the minutes, and then press [ ALARM ] to confirm. The display
then automatically shows the duration of the alarm while “ ” and
“ ” flash on the display.
3) Turn the [ TUNING ] knob to set the duration of the alarm (01 - 60 minutes).
4) Quick press [ ALARM ] to confirm the setting. The alarm “ ” icon is
shown on the display.
Setting the Alarm Station
1) Select the station frequency you want to use as the alarm.
2) Quick press [ M ], the preset memory location will flash.
3) While still flashing, quick press [ ALARM ], the alarm “ ” icon will flash.
4) While still flashing, quick press [ ] to confirm, “ ” stops flashing
and the setting is complete.
Tips:
If the device is turned off with a volume level below 10, then upon reaching
the alarm time, the device turns on at the default volume level of 10.
Once the preset alarm time is reached, the radio turns on and stays on for
as long as the alarm duration (01 – 60 minutes) was set. To turn off the
device during the alarm playtime, quick press the [ POWER ] button twice.
During the alarm playtime, quick press [ POWER ]. This will deactivate the
alarm after which you can change to a different frequency.
After setting the alarm, if the device is not used for three days, then the
alarm will automatically deactivate.
)
To Next Page
Loading...
Need help?
General
