www.tecsunradios.com.au
18
Display Mode
When listening to the radio, quick press [ DISPLAY ] repeatedly to select
your preferred display mode. The top right corner of the display can show
signal strength/signal-to-noise ratio, clock time, alarm time, or the memory
location of the frequency (in VM mode only).
Add Seconds to the Clock
With the device turned off, press and hold [ 8 ] to add seconds to the clock.
Press and hold [ 8 ] again to hide the seconds from the clock.
Display Backlight
With the device turned on, press and hold [ 5 ] to select your preferred
backlight setting.
“ ”: Backlight is set to always-on.
“ ”: Backlight turns on when a button or tuning knob is used and turns
off after 5 seconds.
Setting the Sleep Timer
1) Turn the device off.
2) Press and hold the [ POWER ] button to enter the sleep timer setting.
3) Rotate the [ TUNING ] knob to select a power-off timer of 1-120 minutes,
or select “ON” to deactivate the sleep timer.
4) Quick press [ ] to confirm. The sleep timer “ ” icon is shown on
the display.
Activating/Deactivating the Alarm
Quick press [ ALARM ] to activate the alarm. The alarm “ ” icon is
shown on the display to indicate that the device will turn on at the preset
time. Quick press again to deactivate the alarm.
To Next Page
Loading...
Need help?
General
