13
PL-398MP
2. With ATS in SW (mode B), those existing memories will
not be replaced; all the newly found radio stations will be
stored in the blank memory addresses.
3. If there is too many interference in your surrounding or
many mirror/blank stations are being stored during ATS,
you should contract the telescopic antenna (FM & SW)
or rotate the radio for better reception (MW & LW).
METHOD 2: STORING STATON MANUALLY
1. Select band and tune to your desired station.
2. Press the [M] button with “ PRESET ” flashing
3. Press the [M] button again to store the station into
memory.
You can also wait for 3 seconds to auto store the station
into memory.
METHOD 3: SEMI-AUTO STORING STATIONS
While operating the “Auto Browse Station” function, you
can simply press on the [M] button to store the station into
memory to avoid storing unwanted stations and interfering
signals.
1. Press the [VF] button to switch into frequency mode.
2. Press & hold the [VF] button until “ “ advancing on the
screen to auto browse from one station to another.
3. While tuning to your desired station, press the [M] button
followed by “ PRESET ” flashing to directly store the station
into the next available memory. The unit will keep on
browsing until you deactivate it by pressing on the [VF]
button again.
To Next Page
Loading...
