Tecsun PL-398MP - LISTENING TO STORED STATIONS; MANUAL MEMORY TUNING; AUTO BROWSE MEMORY; DIRECT KEY IN MEMORY ADDRESS

14 PL-398MP
LISTENING TO STORED STATIONS
METHOD 1: MANUAL MEMORY TUNING
Press the [VM] button to enter the
memory mode, then rotate the
[TUNING] knob to tune into the
stored stations one by one.
Memory address
SLEEP
address state
METHOD 2: AUTO BROWSE MEMORY
1. Press the [VM] button followed by
“memory page” appearing in the
upper right corner to enter the
memory mode.
2. Press & hold the [VM] button until
“PRESET ” flashing to auto scan
from one memory to another,
staying on each station for about
5 seconds.
To stop auto search memory,
simply press the [VM] button.
flashing
Auto browse preset station
SLEEP
METHOD 3: DIRECT KEY IN MEMORY ADDRESS
1. Press the [VM] button to enter the memory mode.
2. Press the numeric keys [0] - [9] to enter the memory
address directly, and then press the button to
confirm.
Note: If the display shows “ - - - - ”symbol after entering
the number, it means the entered memory address
does not exist.