PL-505 9
WORKING WITH STATION MEMORIES
There are in total 550 preset memories within the unit. 100
preset memories for each FM, MW, and LW band, and 250
for SW. You can use either of below methods to tune and
store those stations into memories:
1.
FM ATS:
1. Fully extend the telescopic
antenna and press the [FM]
button to select FM band.
2. Press & hold the [FM] button
until “PRESET ” flashing and
the frequency advancing;
now the unit starts scanning
and storing all available
stations into the memories.
When the frequency stops
advancing, it means the ATS
operation has been done
completely; you can rotate the
[TUNING] knob to search
around for those scanned and
stored stations.
MW/LW ATS:
Press the [MW] button to select MW/LW band, then follow
step 2 of FM ATS.
SW ATS:
Fully extend the telescopic antenna and press the
ATS (Auto Tuning Storage)
SW[ ]
or [ ] button to select SW band. There are two modes for
SW ATS tuning:
Mode A: Press & hold the [ ] button to ATS the stations
within present meter band.
Mode B: Press & hold the [ ] button to ATS the stations
within all meter bands.
flashing
Auto Tuning storage (ATS)
status
Station
Storage #
To Next Page
Loading...
Need help?
General
