PL-50510
Notes:
1. During ATS process in FM, MW / LW or SW (mode B),
pre-stored radio stations will be replaced automatically
by the new searched stations.
2. With ATS in SW (mode A), those existing memories will
not be replaced; all the newly found radio stations would
be stored in the blank memory address.
3. If there is too many interference in you surrounding or
many mirror/blank station are being stored during ATS,
you should contract the telescopic antenna (FM & SW)
or rotate the radio for better location (MW & LW).
2. STORING STATONS MANUALLY
1. Select band and tune to your desired station.
2. Press the [MEMORY] button with “PRESET ” flashing
3. Press the [MEMORY] button again to store the station
into memory.
You can also wait for 3 seconds to auto store the station
into memory.
3. SEMI-AUTO STORING STATION
While operating the While auto browsing the station, you
can simply press the [MEMORY] button to store the station
into memory to avoid storing unwanted stations and
interfering signals.
1. Press the [VF] button to switch into frequency mode.
2. Press & hold the [VF] button with “ “ advancing to
auto browse from one station to another.
3. While tuning to your favor station, press the [M] button
with “PRESET ” flashing to direct store the station into the
next available memory. The unit will keep on browsing
until you deactivate it by pressing on the [VF] button
again.
To Next Page
Loading...
