Tecsun PL-505 - Working with Alarm; Setting the Alarm Time; How to Set Alarm by Radio

SLEEP
PL-505 15
WORKING WITH ALARM
1. SETTING THE ALARM TIME
2. HOW TO SET ALARM BY RADIO
You can preset the alarm station
following below steps:
1. Turn on the radio, then tune into
your favorite station for the alarm
by radio and adjust your desired
alarm volume level.
2. Press the [MEMORY] button
followed by “ PRESET ” flashing in
the display, then immediately
press the [ALARM] button and
notices “ ” appearing in the
display to confirm the preset
alarm station.
flashing
1. Press & hold the [ALARM] button with hours flashing on
the display, then rotate the [TUNING] knob to adjust the
hours.
2. Press the [ALARM] button with minutes flashing, then
rotate the [TUNING] knob to adjust the minutes while
minutes is flashing
3. Press the [ALARM] button again, then rotate the
[TUNING] knob to select from 1 ~ 90 minutes to set the
“Auto Alarm Off” Timer.
4. Press the [ALARM] button to confirm the setting.
5. To turn off the alarm, press the [ALARM] button
repeatedly with “ “ disappears.
※ If the [ALARM] button has not been pressed again within
3 seconds, the unit will automatically confirm the alarm
setting.