If the disassembly of safety devices is necessary with servicing or repairing, the assembly and examination of
safety devices must take place immediately after conclusion of maintenance and repair work!
At the beginning of maintenance/repair/care the Mistral, and here in particular connections and screw
connections are to be cleaned of all contamination and residues, e.g. dust, fuels or preservative agents.
Do not use aggressive cleaning agents containing solvent Use a lint free cleaning cloths.
Use only mild cleaning agents on water basis. Consider the data of the manufacturers.
Do not use organic solvents, since fire and danger of explosion exists!
Provide for safe and environmental careful disposal of operating and auxiliary materials as well as
replacement parts!
2.9. Referring to special danger kinds
2.9.1. Electricity
The work on the electrical equipment of the Mistral may be made only by an electrical specialist or personnel
instructed by/under line and supervision of an electrical specialist, in accordance with the electrical rules!
It must be waited always five minutes after switching off, so that the inserted condenser in the control board
can unload themselves. Opening of the housing is only permissible at the end of this time.
Use only original safety devices with prescribed amperages!
Never accomplish work on live parts!
With repairs pay attention to the fact that constructional characteristics are not to be safety reducing changed
in particular: allowed air creeping and air clearance as well as distances are not to be made smaller by
isolations.
The perfect grounding of the electrical system must be ensured by a protective grounding system.
Program modifications at the control system may be made only in consultation with Trotec Produktions- u.
Vertriebs GmbH or directly with the manufacturing firm.
With disturbances at the electrical power supply separate immediately the Mistral from the net, by:
– switching off the Mistral at the transparency keyboard and thereafter
– disconnecting the plug from the mains.
2.9.2. Types of dust and other chemical substances
With the Mistral partial toxic types of dust from contaminated air are filtered. Depending upon the kind of the
assigned materials these types of dust can be health-endangering and/or carcinogenic.
While handling toxic types of dust special caution is required.
Consider and keep valid regulations and safety data sheets of the manufacturers concerning storage,
handling, employment and disposal, while handling chemical substances.
With eye or skin contact with the types of dust in the filters or the suction hose the part concerned must be
flushed immediately with much water. Suitable mechanisms (eye wash bottle, wash basin, shower) must be
available at hand!
By cleaning and disinfectants loaded skin should be maintained after washing. Irritation can be avoided by
the preventing use of skin protection means and a suitable skin care. The preservative agent which can be
used is to be selected as a function of the pollution impact and the individual condition of the skin. Containing
fat preservative agents are predominantly applicable.
Operating Instructions Mistral (Plus), Mistral Eco (Plus), Mistral Super Plus 110 and 230V vers. 4.10 Page 14 of 47
To Next Page
Loading...