6.7. Test operation
Reference!
Accomplish the test operation, if you have acquired the Mistral and want to know/learn the functions.
Accomplish the test operation in addition, if you attached the Mistral to (new) a remote control or disturbances
at the Mistral have been repaired before.
Accomplish the test of the Mistral as follows:
● Examine first all connections at the Mistral for correctness and a firm seat.
● Connect the Mistral to the mains supply.
● Switch the Mistral on at the transparency keyboard with the key . Important: When switching
on at the keyboard hold on the ON / OFF button for about 0,5 seconds.
Alternatively you switch the machine on which can be exhausted. The Mistral is switched on
automatically.
● Increase the number of revolutions of the turbine(s), by touching lightly and keeping the key
pressed. You can notice the increase of the number of revolutions at the noise increase. In addition
in the display increases the right %-announcement.
● Increase the number of revolutions of the Turbine(n) to 100 %. The left %-announcement must
thereby rise a little.
● Reduce afterwards the number of revolutions of the turbine(s), by touching lightly and keep
the key pressed. You can notice the reduction of the number of revolutions at the noise acceptance.
In addition the right %-announcement in the plain language announcement (minimum on 20 %) is
reduced.
● If you operate the Mistral at a remote control, examine now also all existing functions. These can
be:
– direct OFF/and again switching ON of the Mistral,
– increasing the number of revolutions,
– reducing the number of revolutions,
– automatic switching OFF of the Mistral, if the machine is switched off,
– automatic switching ON of the Mistrals, if the machine is switched on.
● Afterwards switch the Mistral off at the transparency keyboard with the key .
Alternatively switch off the machine which can be exhausted. The Mistral is switched off
automatically after the adjusted time.
If the test operation ran off to your satisfaction and without malfunctions the Mistral is now ready for
operation.
Operating Instructions Mistral (Plus), Mistral Eco (Plus), Mistral Super Plus 110 and 230V vers. 4.10 Page 28 of 47
To Next Page
Loading...