Teka Mistral Plus - Transport, Storage, and Start-up; Transport and Handling Guidelines

4. Transport, storage and start-up
4.1. Transport on wooden palette
The Mistral is transported on a wooden pallet. The following corridor promotion vehicles are permissible for
the transport of the wood pallet:
– Fork lift and
– Fork truck.
Hard impacts of the Mistral (e.g. on the loading area of a transport vehicle) must be avoided when setting off.
Secure the wood pallets with the Mistral in the case of transport against tilting.
Imprinted arrows on the transportation crates must show upward.
Consider the valid accident prevention and industrial safety regulations.
Consider absolutely danger warnings and information on the packing!
The Mistral and/or the wood pallet with the Mistral is to be secured on the transport vehicle against slipping
and tilting.
Information!
Unpack the Mistral only at the place of assembly.
Do not set up the Mistral in direct proximity of heating/heating elements.
Consider sufficient area for the exchange of the filter-unit when setting up.
Proceed when unpacking and setting up the Mistral as follows:
● Lift the Mistral off the wood pallet and/or from the transportation packing only at the place of
assembly. Remove the packing carefully.
● Examine the completeness of the supply on the basis of the packing list. If parts should be missing
or supplied wrongly, contact immediately the Trotec Produktions- u. Vertriebs GmbH. The same
applies to transport damages.
● In addition do examine the complete supply for outside damage, which may have developed e.g. in
the case of transport.
● Transport the Mistral afterwards attentively and prudently on its guiding rollers up to the place of
assembly.
● Set up the Mistral to even, firm underground.
● Always check that the Mistral stands secured and that the guiding roller’s brakes are set.
● Set up the Mistral in such a way, that the attached suction hoses between the Mistral and machine
which can be exhausted do not lie in through ways and/or generally do not have to be exceeded.
4.2. Scope of supply
Examine with the delivery of the Mistral the scope of supply in every detail and announce immediately if parts
are missing or should be damaged. Later complaints are not accepted.
To the regular scope of supply belong:
– Mistral, completely (with inserted filter-unit); mains cable (cold equipment cable);
– Blind cover (inserted in the extraction inlets).
Please note that the scope of supply can deviate in individual cases from this list. In this case the list in the
delivery document is binding.
Operating Instructions Mistral (Plus), Mistral Eco (Plus), Mistral Super Plus 110 and 230V vers. 4.10 Page 20 of 47