Error Cause Elimination
Suction power too small
(Smoke/gases are hardly sucked
off) the turbine does not reach the
necessary speed.
Overheating through huge filter
pollution.
Turn off the Mistral, exchange the
filter-unit. Switch on the Mistral
only after the turbine has cooled
itself.
Failure on the Mistral. Contact the Trotec Produktions- u.
Vertriebs GmbH. If necessary
send the Mistral to Trotec.
The Mistral does not start. Plug connection of the current
supply is not or wrongly put in.
Examine the connection of the
current supply, if necessary
connect correctly.
No current on plug socket. Examine current mains, if
necessary repair disturbance.
Connecting cable for external
control not or wrongly plugged in.
Examine the connecting cable for
the external control, if necessary
plug in correctly.
No control signal for remote
control of the machine.
According to the manual eliminate
disturbance.
Failure on the Mistral. Contact the Trotec Produktions- u.
Vertriebs GmbH. If necessary
send the Mistral to Trotec.
Motor stops within operation. Overheating through huge filter
pollution. The thermal protection of
the turbine is released.
Turn off the Mistral, exchange the
filter-unit. Switch on the Mistral
only after the turbine has cooled
itself.
The turbine is stalled through
tearing of the filter unit!
No warranty claim is given!
The exchange of the turbine is
necessary. The filter-unit and the
activated carbon must be
exchanged also. It is absolutely
necessary that all parts of the
Mistral have to be cleaned, in
particular the housing inside.
Operating Instructions Mistral (Plus), Mistral Eco (Plus), Mistral Super Plus 110 and 230V vers. 4.10 Page 38 of 47
To Next Page
Loading...