Teknoware TKT66 - DIP switch settings in circuit boards

VOT1; Rev 1.5; EN; 5.11.2015
TKT66 – Installation and maintenance
28
5.2.3 DIP switch settings in circuit boards
The DIP switch number 4 must be used to select a desired operating mode for each board. When the
DIP switch number 4 is in the 'OFF' position, the circuit board operates according to the addressable
luminaire monitoring principle.
When the DIP switch number 4 is in the 'ON' position, the circuit board operates according to the circuit
monitoring principle.
The factory setting for the circuit boards is addressable monitoring.
For more information, see Chapters 4.3 Circuit board settings and 4.4 Parallel connection of output
circuits.
Addressable monitoring
active (Factory settings)
Circuit monitoring
active