TekPower TP40 - 2.3 Keypad

4
AUTO
The meter is in the Autorange
mode in which the meter
automatically selects the range
with the best resolution.
5
PC-LINK
The Meter is in the data
transmission mode.
6
NCV
No contact AC Voltage detect
7
H
The meter is in Data Hold
mode.
8
REL
The meter is in Relative
Measurement mode.
9
MAX
Display maximum data
10
MIN
Display minimum data
11
Low battery indication
12
The meter is in Continuity
Check mode.
13
The meter is in Diode Test
mode.
14
%℃℉ KMHz
nμmFAV
Measurement units
15
This symbol means that the
input is too large for the
selected range.
2.3 Keypad
2.3.1 SELECT