Compliance Info
rmation
Australia / New Zealand Declaration of Conformity – EMC
Complies with the EMC provision of the Radio c ommunications Act per the following standard, in accordance with ACMA:
CISPR 11:2003. Radiated and Conducted E missions, Group 1, Class A, in accordance with EN 61326-1:2006.
Safety Compliance
EC Declarati
on of Conformity – Low Vo ltage
Compliance w as demonstrated to the following specification as listed in the Official Journal of the European Communities:
Low Voltage Directive 2006/95/EC.
EN 61010-1: 2001. Safety requirements for electrical equipment for measurement control and laboratory use.
U.S. Nationally Recognize d Testing Laboratory Listing
UL 61010-
1:2004, 2
nd
Edition. Standard for electrical measuring and test equipment.
Canadian Certification
CAN/CSA-C22.2 No. 61010-1:2004. Safety requirements for electrical equipment for m easurement, control, and
laboratory use. Part 1.
Additional Compliances
IEC 61010-1: 2001. Safety requirements for electrical equipment for measurement, control, and laboratory use.
Equip
ment Type
Test and measuring equipment.
Safety Class
Cla
ss 1 – grounded product.
Pollution Degree Desc ription
A measure of the contaminants that could occur in the environment around and within a product. Typically the internal
environment inside a product is considered to be the same as the external. Products should be used only in the environment
for which they are rated.
Pollution Degree 1. No pollution or only dry, nonconductive pollution occurs. Products in this category are generally
encapsulated, hermetically sealed, or located in clean rooms.
Pollution Degree 2. Normally only dry, nonconductive pollution occurs. Occasionally a temporary conductivity that is
caused by condensation m ust be expected. This location is a typical office/home environment. Temporary condensation
occurs only when the product is out of service.
vi AWG5000 and AWG7000 Series Quick Start User Manual
To Next Page
Loading...
Need help?
General
