Saving and Recal
ling Setups
4. Select a file to import.
5. Select an import action in the Operation
frame.
Set to – Select the channel and index
number. The i
mported waveform
data w ill be assigned to the specified
position.
Insert before – The imported
waveform da
ta will be inserted
before the specified cell of the
sequence. When the run mode is
non-seque
nce, this parameter is
disabled.
Create only – The imported
waveform will be added to the
Waveform L
ist window.
Overwrit
e – Specified existing
waveform data is overwritten.
6. If the imported waveform data contains
information on sampling rate, amplitude,
or offset, you can select whether you
load that information using the Change
H/W Setup.
For example, if you check the Sampling
Rate check box, the sampling rate will be
modified to reproduce the same signal
as the imported data.
7. Click Open.
When the import file format is *.AWG,
*.DTG, or *.TXT, a corresponding dialog
box is displayed.
When the import file format is other than
*.AWG, *.DTG, or *.TXT, the selected file
is imported and the waveform name(s)
are listed in the Waveform List window.
AWG5000 and AWG7000 Series Quick Start User Manual 45
To Next Page
Loading...
Need help?
General
