EasyManua.ls Logo

Tektronix DPO71254C

Tektronix DPO71254C
920 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Opt. CA1 - Provides single calibration event for the designated interval
Opt. R3 - Repair service 3 years (including warranty)
Opt. R5 - Repair service 5 years (including warranty)
Software:
MSO70000C/DX, and DPO70000C/DX Series:
Opt. BRR - BroadR-Reach Compliance Testing
Opt. DDRA - DDR Memory Bus Analysis
Opt. DJA - Advanced Jitter and Eye Analysis (standard on MSO instruments)
Opt. D - PHY MIPI D-PHY Transmitter Debug, Characterization, and Compliance Test Solution (requires DJA)
Opt. DP12 - DisplayPort 1.2 Source Test Automation (requires Opt. DJA and Opt.5XL or higher)
Opt. ERRDT - Frame and Bit Error Rate Detector in high speed serial standards (requires option ST6G).
Opt. ET3 - Ethernet Compliance Test
Opt. HSIC – HSIC Essentials - Electrical Validation and Protocol Decode Solution (Requires Opt. DJA)
Opt. HT3 - HDMI Compliance Test
Opt. HT3DS - HDMI Direct Synthesis for HDMI 1.4 Compliance Test
Opt. M - PHY - MIPI M-PHY Essentials – Characterization and Analysis Solution (Requires Opt. DJA)
Opt. M - PHYTX - M-PHY Automated Transmitter Solution (requires DJA)
Opt. M - PHYRX - M-PHY Automated Receiver Solution (Requires Opt. ST6G) (Requires Opt. ERRDT)
Opt. MTH - Mask Testing for serial standards, 4.25 GB/s (standard on MSO instruments)
Opt. MOST - Electrical Compliance and Debug Test Solution for MOST50 and MOST150 (Requires Opt. DJA)
Opt. PCE3 - PCI Express
®
Transmitter Compliance and Debug (Requires Opt. DJA) (For models of bandwidth ≥6 GHz
only)
Opt. PWR - DPOPWR Power Measurements and Analysis
Opt. QPI - Intel
®
Quick Path Interconnect Test Automation Software (Requires Opt. DJA)
Opt. SAS3 - SAS3 12 GB/s Essentials (Requires Opt. DJA and 2XL or higher) (For models of bandwidth ≥20 GHz only)
Opt. SFP-TX - SFP+ Compliance and Debug Solution (Requires Opt. DJA)
Opt. SFP-WDP - SFP+ Compliance and Debug Solution – WDP Measurement (Requires Opt. DJA)
Opt. SDLA64 - Serial Data Link Analysis Visualizer
Opt. SR-AERO - MIL-STD-1553 Serial Triggering and Analysis
Opt. SR-AUTO - Automotive Serial Triggering and Analysis (CAN, LIN, FLEXRAY)
Opt. SR-COMP - Computer Serial Triggering and Analysis (RS-232/422/485/UART)
Opt. SR-DPHY - MIPI-D-PHY (DSI1/CSI2) Serial Analysis
Opt. SR-EMBD - Embedded Serial Triggering and Analysis (I2C, SPI) (standard on MSO instruments)
Opt. SR-ENET - Ethernet Serial Analysis (10BASE-T and 100BASE-TX)
Opt. SR-PCIE - PCI Express Compliance Module for RT-Eye Serial Data Compliance and Analysis
Opt. SR-USB - USB Serial Triggering and Analysis (LS, FS, HS)
About Tektronix oscilloscopes
DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series 13

Table of Contents

Other manuals for Tektronix DPO71254C

Related product manuals