Commands Listed in Alphabetical Order
COMPensate:S
TATus:CH<x>? (Query Only)
This is a query only command that returns the current compensation status for
the module channel. Possible responses are DEFaults, WARMup, FAIL, PASS,
and COMPReq.
Group
Compensation
Syntax
COMPensate:STATus:CH<x>?
Examples
COMPENSATE:STATUS:CH1? might return COMPENSATE:STATU S:CH1
COMPREQ
, indicating that the warm-up p
eriod for the instrument has elapsed, but
the current compensation temperature delta is greater than desired, or that the
specified module has been moved to a different module compartment since last
compensated. In either case, the instrument should be compensated again.
COMPensate:STATus:MAInframe? (Query Only)
This is a query only command that returns the current compensation status for
the mainframe. Possible responses
are DEFaults, WARMup, FAIL, PASS, and
COMPReq.
Group
Compensation
Syntax
COMPensate:STATus:MAInfra me?
Examples
COMPENSATE:STATUS:MAINFRA ME? might return
COMPENSATE:STATUS:MAINFRA ME PASS, indicating that the current
compensation data should allow the instrument to meet operating specifications.
COMPensate:TEMPerature:CH<x>? (Query Only)
This query only command returns the difference (in °C) between the current
temperature of the module channel and the associated temperature currently
residing in the in-use run-time compensation m emory.
Group
Compensation
Syntax
COMPensate:TEMPerature:CH <x>?
2-98 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
