Commands Listed in Alphabetical Order
503250944,501
088256,501743616,503447552,
498139136,502857728,507248 640,507117568,
503054336,506200064,505413 632,502988800,
506658816,506920960,498008 064,501415936,
504299520,498991104,496304 128,499056640,
501612544,505806848,498794 496,494206976, 414449664,
-11141120,
-274071552, -394330112, -432865280, -450756608,
-488439808,-500826112.
...
DATa
This command sets or queries the format and location of the waveform data that is
transferred with the CURVe command.
Group
Waveform Transfer
Syntax
DATa { INIT | SNAp }
DATa?
Related Commands
CURVe, WAVF r m ? , DATa:STARt, DATa:STOP
Arguments
INIT initializes the waveform data parameters to their factory defaults.
SNAp sets DATa:STARt and DATa:STOP to match the current vertical bar
cursor positions.
Examples
DATA SN AP assigns the current position of the vertical bar cursors to
DATA:START and DATA:STOP.
DATA? might return DATA:DESTINATION REF1 ;SOURCE CH3;ENCDG
ASCII;START 1;STOP 500
.
DATa:DESTination
This command sets or queries the destination reference memory location for
storing waveform data that is transferred into the instrument by the CURVe
command.
Group
Waveform Transfer
DSA/CSA/TDS8X00/B Series Programmer Manual 2-109
To Next Page
Loading...
Need help?
General
