Commands Listed in Alphabetical Order
Examples
SYSTEM:PROPER
TIES:CH3:PROBE:DYNAMIC?
might
return
SYSTEM:PROPERTIES:CH3:PROBE DYNAMIC
–4.00000000000E–001,4.0000 0000000E–001
, indicating that the output
dynamic range of the probe attached to Channel 3 is -4.0 to +4.0 (with the
applicable unit of measure determined by the type of probe and sampling module
for the channel).
SYSTem:PROPerties:CH<x>:PRObe:IMPedance? (Query Only)
This query only command returns the characteristic input impedance of a probe
attached to the channel specified by x, which can be 1 through 8.
Group
System
Syntax
SYSTem:PROPerties:CH<x>:PR Obe:IMPedance?
Examples
SYSTEM:PROPERTIES:CH1:PROB E:IMPEDANCE? might return
SYSTEM:PROPERTIES:CH1:PROB E IMPEDANCE 1.00000000000E+005,
indicating that the characteristic input impedance of the probe attached to Channel
1 is 100 kΩ.
SYSTem:PROPerties:CH<x>:PRObe:MODElnum? (Query Only)
This query only command returns the model n umber of the probe attached to the
channel specified by x, which can be 1 through 8.
Group
System
Syntax
SYSTem:PROPerties:CH<x>:PR Obe:MODElnum?
Examples
SYSTEM:PROPERTIES:CH3:PROB E:MODELNUM? might return
SYSTEM:PROPERTIES:CH3:PROB E MODELNUM " P6209", indicating that a
Tektronix P6209 FET probe is attached to Channel 3.
SYSTem:PROPerties:CH<x>:PRObe:SCAle? (Query Only)
This query only command returns the scale factor of a probe attached to the
channel specified by x, which can be 1 through 8.
DSA/CSA/TDS8X00/B Series Programmer Manual 2-287
To Next Page
Loading...
Need help?
General
