Commands Listed in Alphabetical Order
Examples
TRIGGER:CLKRE
C:CRC:SERIALNUM?
might return
:TRIGGER:CLKREC:CRC:SERIAL NUM B010112.
NOTE. undefined is returned if a Clock Recovery instrument is not present.
TRIGger:CLKRec:CRC:STANdard
This comman
d sets or queries the communications standard of the connected
Clock Recovery instrument. Selecting a new standard changes the Clock
Recovery instrument settings for NOMFREQUENCY, LOCKRANGE,
LOOPBANDWIDTH, PEAKING, and NOMEDGEDENSITY.
Group
Trigger
Syntax
TRIGger:CLKRec:CRC:STANdar d <QString>
TRIGger:CLKRec:CRC:STANdar d?
Arguments
QString is the names of the clock recovery standard.
Examples
TRIGGER:CLKREC:CRC:STANDAR D "GBE10" sets the clock recovery standard
of the Clock Recovery instrument to GBE10.
TRIGGER:CLKREC:CRC:STANDAR D? might return
:TRIGGER:CLKREC:CRC:STANDA RD OC12 indicating that the currently selected
standard of the Clock Recovery instrument is OC12.
TRIGger:CLKRec:CRC:STANDARDList? (Query Only)
This query only command returns a comma-separated list of the standa rds
available on the connected Clock Recovery instrument.
Group
Trigger
Syntax
TRIGger:CLKRec:CRC:STANDAR DList?
Examples
TRIGGER:CLKREC:CRC:STANDAR DLIST? might return
:TRIGGER:CLKREC:CRC:STANDA RDLIST SATA1(0.9), SATA1(1.98), …
indicating these are the standards supported by the connected Clock Recovery
instrument.
DSA/CSA/TDS8X00/B Series Programmer Manual 2-325
To Next Page
Loading...
