Tektronix DSA8200 Series User Manual

Commands Listed in Alphabetical Order
Syntax
WFMInpre:YSCA
LE <NR3>
WFMInpre:YSCALE?
Arguments
NR3 is the value of the vertical scale factor. Note that the argument is always 1
when DATA :SOURCE is set to a math waveform.
Examples
WFMINPRE:YSCALE 9.20E-10 sets the vertical unit scale factor of the incoming
waveform to 920E-12.
WFMINPRE:YSCALE? might return WFMINP RE:YSCALE 9.20E10, indicating that
the vertical unit scale factor of the incoming waveform is 920 pV.
WFMInpre:YUNit
This command sets or queries the vertical (y-axis) units of the incoming waveform.
Group
Waveform Transfer
Syntax
WFMInpre:YUNit <QString>
WFMInpre:YUNit?
Related Commands
CH<x>:UNIts
Arguments
Qstring sets the vertical units of the incoming waveform.
Examples
WFMINPRE:YUNIT "W" sets the vertical units of the incoming waveform to watts.
WFMINPRE:YUNIT? might return WFMINPRE
:YUNIT "V"
, indicating that the
vertical units of the incoming waveform are volts.
WFMInpre:YZEro
This command sets or queries the vertical offset voltage of the incoming
waveform.
Group
Waveform Transfer
Syntax
WFMInpre:YZEro <NR3>
WFMInpre:YZEro?
DSA/CSA/TDS8X00/B Series Programmer Manual 2-363

Tektronix DSA8200 Series Specifications

General

Brand	Tektronix
Model	DSA8200 Series
Category	Test Equipment
Language	English