Commands Listed in Alphabetical Order
WFMOutpre:XI
Ncr? (Query Only)
This is a query only command that returns the interval between samples of the
waveform transferred by the CURVe? command.
Group
Waveform Transfer
Syntax
WFMOutpre:XINcr?
Related Commands
HORizontal:MAIn:RESolution?
Examples
WFMOUTPRE:XINCR? might return WFMOUTPRE:XINCR 5.00000000000E-00 9,
indicating that the interval between samples of the previously transferred
wavefor
mwas5ns.
WFMOutpre:XMUlt? (Query Only)
This is a query only command that returns the horizontal scale factor of the
waveform returned by the previous CURVe? command.
Group
Waveform Transfer
Syntax
WFMOutpre:XMUlt?
Related Commands
HORizontal:MAIn:SCAle
Examples
WFMOUTPRE:XMULT? might return WFMOUTPRE:XMULT 5.00000000000E-00 6,
indicating that the horizontal scale factor of the previously transferred waveform
was set to 5 µs per division.
WFMOutpre:XOFf? (Query Only)
This is a query only command that returns the horizontal position in horizontal
units of the returned waveform.
Group
Waveform Transfer
Syntax
WFMOutpre:XOFf?
DSA/CSA/TDS8X00/B Series Programmer Manual 2-369
To Next Page
Loading...
