Commands Listed in Alphabetical Order
Related Commands
HORizontal:MA
In:POSition
Examples
WFMOUTPRE:XOFF? might return WFMOUTPRE:XOFF 20.50000000008E -009,
indicating that the horizontal position for the previously transferred waveform
was set to 20.5 ns
.
WFMOutpre:XUNit? (Query O nly)
This is a query only command that returns the horizontal units of the waveform
returned by the previous CURVe? command.
Group
Waveform Transfer
Syntax
WFMOutpre:XUNit?
Related Commands
HORizontal:UNIts
Examples
WFMOUTPRE:XUNIT? might return WFMOUTPRE:XUNIT "S", indicating that the
horizontal units of the previously acquired waveform were seconds.
WFMOutpre:XZEro? (Query Only)
This is a query only c ommand that returns the time of first point (sample) of the
waveform returned by the previous CURVe? command.
Group
Waveform Transfer
Syntax
WFMOutpre:XZEro?
Related Commands
HORizontal:MAIn:TOFPoint?
Examples
WFMOUTPRE:XZERO? might return WFMOUTP RE:XZERO
19.00000000008E-009
, indicating that the time interval between
the trigger point and the first point in the previous waveform record was 19 ns.
2-370 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
