Tektronix DSA8200 Series - Page 386

Commands Listed in Alphabetical Order
Group
Waveform Trans
fer
Syntax
WFMOutpre:YSCALE?
Examples
WFMOUTPRE:YSCALE? might return WFMOUTPRE:YSCALE
9.200000000000E10
, indicating that the vertical unit scale factor of
the incoming waveform is 920p.
WFMOutpre:YUNit? (Query O nly)
This is a query only command that returns the
vertical units of the waveform
returned by the previous CURVe? command.
Group
Waveform Transfer
Syntax
WFMOutpre:YUNit?
Related Commands
CH<x>:UNIts
Examples
WFMOUTPRE:YUNIT? might return WFMOUTPRE:YUNIT "V", indicating that the
vertical units of the previously transferred waveform were volts.
WFMOutpre:YZEro? (Query Only)
This is a query only command that returns the vertical offset of the w aveform
returned by the previous CURVe? command.
Group
Waveform Transfer
Syntax
WFMOutpre:YZEro?
Related C
ommands
CH<x>:OFFSet
Examples
WFMOUTPRE:YZERO? might return WFMOUTPRE:YZERO 1.00000000000E-001,
indicating that the vertical offset of the previously transferred waveform was
100 mV.
2-372 DSA/CSA/TDS8X00/B Series Programmer Manual