Status and Events
Table 3-5: Execution Error Messages (EXE Bit 4) (cont.)
Code Message
2509
Gated Trigger is not available
2510
Warning – measurement requires waveform database, and none is available
2511
Error saving setup – invalid directory path or file
2512
Could not close file
2513
Could not open file to read
2514
Can't write to file; media a ccess violation
2515
Reference slot is out or range (1 – 8)
2516
Reference slot is active; cannot recall data into active slot
2517
Error reading waveform file
2518
Incompatible file version
2519 File path is not valid
2520
Waveform database is not properly released
2521
Reference data are not properly released
2522 Unable to restore setup
2523
Not enough mag points (<10) to save
2524 Directory does not exist; unable to c reate the directory
2525 Histogram contains invalid data
2526
The file can not be removed
2527
Source already active in another Database
2528
User-defined clock recovery not available
2529
Int Clk incompatible with Phase Correction Mode
2530
Phase Ref Module not available
2531
TDR Step incompatible with phase Correction
2532
Phase Correction m ode is off
2533
Clock Recovery source not available
2534
Clock R ecovery rate not available
2535
Unit selection incompatible with Phase Ref mode
2536
Trigger Mode incompatible with Trigger Source
2537
Pattern Sync source not available
2538
Pattern Sync Module not available
2539
Pattern Sync Parameter not settable
2540 Autoset error, Failed to complete
2541 Autoset warning, Nothing to autoset
2542
Autoset error, Signal offset out of range
2543
Autoset error, Trigger not found
2544 Autoset error, Trigger Amplitude too small
2545
Autoset error, Signal Amplitude too small
3-16 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
