In this section:
Introduction .............................................................................. 5-1
Line fuse replacement .............................................................. 5-1
Fuse replacement .................................................................... 5-2
Front-panel tests ...................................................................... 5-3
Upgrading the firmware ............................................................ 5-4
Displaying the serial number .................................................... 5-6
Introduction
This section describes routine maintenance of the instrument that an operator can perform.
Line fuse replacement
A fuse on the 2600B rear panel protects the power line input of the instrument. See the following
instructions to replace the fuse. You do not need to return your instrument for service if the fuse is
damaged.
Disconnect the line cord at the rear panel and remove all test leads connected to the
instrument before replacing a line fuse. Failure to do so could expose the operator to
hazardous voltages that could result in personal injury or death.
To Next Page
Loading...
