Commands Listed in Alphabetical Order
Group
Vertical
Syntax
AUXin:PRObe:UNIts?
Examples
AUXin:PROBE:UNITS? might return: :AUXi n:PROBE:UNITS “V” indicating
that the units of measure for the attached probe are volts.
AUXOut:SOUrce
This command sets (or queries) the source for the Auxiliary Output port.
Group
M
iscellaneous
Syntax
AUXOut:SOUrce {ATRIGger|MAIn|REFOut|EVENT|AFG}
AUXOut:SOUrce?
Arguments
ATRIGger is the default signal output of the auxiliary out port. MAIn is
synonymous with
ATRIGger.
REFOut specifies the reference oscillator output as the source for the auxiliary
output. (Not supported on MDO3000 models.)
EVENT refers to an internally generated oscilloscope event. The Mask and Act
on Event commands can cause an event output, such as a mask test completion
notification event.
AFG specifies the AFG sync out pulse. (Only available for MDO3000 and
MDO4000C models with the MDO3AFG or MDO4AFG option installed.)
Examples
AUXOut:SOUrce REFOut sets the instrument to use the reference oscillator
output as the source for the auxiliary output.
AUXOut:SOUrce? might return ATRIGGER, indicating the source for the
auxilliary out port is the A Trigger.
BUS? (Query Only)
Returns the parameters for each serial (if installed) and parallel bus.
Group
Bus
2-156 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
