Commands Listed in Alphabetical Order
BUS:B<x>:PAR
allel:CLOCk:SOUrce
Specifies the clock source waveform for the parallel bus.
Conditions
Requires an MSO/MDO model, with the MDO3MSO option installed for the
MDO3000 series. The MSO4000B and MDO4000/B/C models can trigger on
parallel buses without an application module.
Group
Bus
Syntax
BUS:B<x>:PARallel:CLOCk:SOUrce {CH1|CH2|CH3|CH4 |
D0|D1|D2|D3|D4|D5|D6|D7|D8|D9|D10|D11| D12|D13|D14|D15}
BUS:B<x>:PARallel:CLOCk:SOUrce?
Arguments
CH1–CH4 specifies an analog channel to use the clock source waveform.
D0-D15 specifies a digital channelas the clock source waveform.
(MSO/MDO4000/B models only as well as MDO3000 and MDO400C models
with option MDO3MSO or MDO4MSO installed.)
BUS:B<x>:PARallel:WIDth
This command specifies the number of bits to use for the width of the parallel bus.
Conditions
Requires an MSO/MDO model, with the MDO3MSO option installed for the
MDO3000 series. The MSO4000B and MDO4000/B/C models can trigger on
parallel buses without an application module.
Group
Bus
Syntax
BUS:B<x>:PARallel:WIDth <NR1>
BUS:B<x>:PARallel:WIDth?
Arguments
<NR1> is the number of bits.
BUS:B<x>:POSition
This command specifies the position of the bus waveform on the display.
2-190 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
