Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
NOTE. This comm
and is equivalent to the
WFMOutpre:B YT_Nr command.
(See page 2-95, Waveform Transfer Command Group.)
Group
Waveform Transfer
Syntax
DATa:WIDth <NR1>
DATa:WIDth?
Related Commands
CURVe?,
DATa:SOUrce,
DATa:DESTination,
WFMOutpre:BYT_Nr
Arguments
<NR1> is an integer that indicates the number of bytes per point for the outgoing
wave
form data when queried using the
CURVe? command. For analog channel
and RF_FREQuency, RF_PHASe and RF_AMPlitude traces (MDO4000/B/C
only), the values can be 1 or 2. For digital channels (D0 through D15), the values
can be 1 or 2. For the digital collection (
DATa:SOUrce DIGital), the values
can be 4 or 8. For RF_NORMal, RF_AVERage, RF_MAXHold, or RF_MINHold,
the value can only be 4 as this is 32-bit floating point data.
Examples
DATa:WIDth 2 sets the width of waveform data to be read from the scope to
2bytes.
DATa:WIDth? might return 1, indicating that a width of 1 byte has been set.
DATE
This command specifies the date the oscilloscope displays.
Group
Miscellaneous
Syntax
DATE <Q String>
DATE?
Related Commands
TIMe
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-281

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English