Commands Listed in Alphabetical Order
NOTE. The TEKSe
cure command can take up to five minutes to complete. The
oscilloscope is inoperable during this period.
Group
Miscellaneo
us
Syntax
TEKSecure
Examples
TEKSECURE initializes both waveform and setup memories.
This is a program example of how to generate an SRQ when
TEKSECURE
completes:
# Bit 0 of the DESE (Device Event Status Enable Register)
# enables OPC to be reported to the SESR (Standard Event
# Status Register)
DESE 255
# Bit 0 of the ESER (Event Status Enable Register)
# enables OPC to be summarized in the ESB (Event Status #
Bit) of the SBR (Status Byte Register)
*ESE 255
# Bit 5 of the SRE ( Service Request Enable Register)
enables
# the generation of SRQ when the ESB bit of the SBR
becomes # TRUE
*SRE 32
TEKSECURE;*OPC
When the TEKSECURE operation has completed, the OPC bit of the SESR will be
TRUE and SRQ will have been generated.
TIMe
This command specifies the time that the oscilloscope displays.
Group
Miscellaneous
Syntax
TIMe <Q String>
TIMe?
Related Commands
DATE
2-768 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
