Commands Listed in Alphabetical Order
NOTE. Do not use
DHCP/BOOTP searching if your oscilloscope has been
assigned a static address on a network. If you set this c ommand to ON, the
DHCP/BOOTP search will delete or change your static IP address information.
OFF disables the oscilloscope to search the network for a DHCP or BOOTP server.
Examples
ETHERNET:DHCPBOOTP ON sets the oscilloscope to search for a DHCP or BOOTP
server and assign a dynamic IP address to the oscilloscope.
ETHERnet:DNS:IPADDress
This command specifies the network Domain Name Server (Dns) IP address.
Group
Ethernet
Syntax
ETHERnet:DNS:IPADDress <QString>
ETHERnet:DNS:IPADDress?
Arguments
<QString> is a standard IP address value, enclosed in quotes.
Examples
ETHERNET:DNS:IPADDRESS “128.196.13.3 52” sets the Dns IP address that
the oscilloscope uses to communicate with the network.
ETHERnet:DOMAINname
This command specifies the network domain name.
Group
Ethernet
Syntax
ETHERnet:DOMAINname <Qstring>
ETHERnet:DOMAINname?
Arguments
<QString> is the network domain name, enclosed in quotes.
Examples
ETHERNET:DOMAINNAME “Alpha1.Mycorp.com” sets the domain name that
the oscilloscope uses to communicate with the network.
2-308 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
