Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
ETHERnet:ENE
T:ADDress? (Query Only)
Returns the Ethernet address value assigned to the oscilloscope. This is assigned
at the factory and can not be changed.
Group
Ethernet
Syntax
ETHERnet:ENET:ADDress?
Examples
ETHERNET:ENET:ADDRESS? returns an Ethernet address such as
08:00:11:01:02:03
ETHERnet:GATEWay:IPADDress
This command specifies the remote interface gateway IP address.
Group
Ethernet
Syntax
ETHERnet:GATEWay:IPADDress <QString>
ETHERnet:GATEWay:IPADDress?
Related Commands
ETHERnet:NETWORKCONFig, ETHERnet:IPADDress, ETHERnet:
SUBNETMask
Arguments
<QString> is a standard IP address value, enclosed in quotes.
Examples
ETHERNET:GATEWAY:IPADDRESS “128.143 .16.1” sets the gateway IP
address.
ETHERnet:HTTPPort
This command specifies the remote interface HTTP port value.
Group
Ethernet
Syntax
ETHERnet:HTTPPort <QString>
ETHERnet:HTTPPort?
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-309

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English