Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Arguments
ON turns on this
feature, so that the instrument will generate a screen hard copy to
the default printer upon failure.
OFF turns off t
his feature.
<NR1> = 0 turns off this feature; any other value turns it on.
Examples
MASK:TESt:HARDCopy ON generates a screen shot to the default printer upon
test failure.
MASK:TESt:HARDCopy? might return 0, indicating that the instrument is not set
to generate a screen shot upon failure.
MASK:TESt:REPeat
This command causes the mask test cycle to continuously repeat upon the
completion of the previous test cycle.
A series of examples showing how to use mask commands for typical tasks
is included in an appendix. (See page E-1, Mask/Limit Command Sequence
Examples.)
Conditions
This command requires a DPO4LMT application module for 4000 series models,
and an MDO3LMT application module for MDO3000 series models.
Group
Mask
Syntax
MASK:TESt:REPeat {ON|OFF|<NR1>}
MASK:TESt:REPeat?
Related Commands
MASK:TESt:STATE,
Arguments
ON turns on this feature, so that the mask test cycle repeats continuously uponthe
completion of the previous test cycle.
OFF turns off this feature.
<NR1> is an integer. 0 turns off this featu
re; any other integer turns it on.
Examples
MASK:TESt:REPeat ON
causes the mask test cycle to continuously repeat.
MASK:TESt:REPeat? might return 0, indicating that the mask test cycle is not
set to continuously
repeat.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-389

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English