Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
MASK:TESt:SA
VEIMAGE
This command causes the instrument to copy the screen image to a file on a USB
mass storage device or a mounted network drive if a pass/fail mask test fails. See
the command F
ILESystem:MKDir and other File System commands for more
information on saving to a file.
A series of examples showing how to use mask commands for typical tasks
is included in an appendix. (See page E-1, Mask/Limit Command Sequence
Examples.)
Conditions
This command requires a DPO4LMT application module for 4000 series models,
and an MDO3LMT application module for MDO3000 series models.
Group
Mask
Syntax
MASK:TESt:SAVEIMAGE {ON|OFF|<NR1>}
MASK:TESt:SAVEIMAGE?
Related Commands
MASK:TESt:STATE,
FILESystem:MKDir
Arguments
ON turns on this feature, so that the screen image is copied to a speci
fied file
upon test failure.
OFF turns off this feature.
<NR1> is an integer. 0 turns off this feature; any other integer turns it on.
Examples
MASK:TESt:SAVEIMAGE On copies a screen image to a file upon test failure.
MASK:TESt:SAVEIMAGE? might return 0, indicating that the instrument is not set
to copy a screen image to a file upon failure.
MASK:TESt:SAVEWFM
This command copies the waveform data from all active channels to a file on a
flash memory device such as a USB stick or a network drive. See the command
FILESystem:MKDir and other File System commands for more information on
saving to a file.
A series of examples showing how to use mask commands for typical tasks
is included in an appendix. (See page E-1, Mask/Limit Command Sequence
Examples.)
2-390 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English