Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
SEARCH:SEARCH
1:TRIGGER:A:BUS:B1:FLEXRAY:DATA:SIZE?
might return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:DATA:SIZE 1 indicating
the data size is 1 byte.
SEARCH:SEAR
CH<x>:TRIGger:A:BUS:B<x>:FLEXray:DATa:VALue
This command specifies the low value to use when searching on the FlexRay bus
data field. The search condition needs to be set to ID or IDANDDATA (using
TRIGger:A
:BUS:B<x>:FLEXray:CONDition).
SEARCH<x> is the search number,
whichisalways1,and
B<x>
Conditions
This command requires a DPO4AUTOMAX application module for
DPO/MSO4000B and MDO4000/B/C models or MDO3FLEX application module
for MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:DATa:VALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:DATa:VALue?
Re
lated Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:CONDition
Arguments
<QString> is a quoted string that is the low binary data string to be used for a
FlexRay search if the search condition is set to
IDANDDATA.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:DATA:VALUE
“11001010”
sets the binary data string to 11001010.
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:DATA:VALUE? might
return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRAY: DATA:VALUE
"XXXXXXXX"
indicates the binary data string is don't cares.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:EOFTYPE
This command specifies which end of file type to use (static, dynamic or any)
when searching on the FlexRay bus EOF field. The search condition needs to be
set to EOF (using SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:
CONDition).
SEARCH<x> is the search number, which is always 1, and B<x>
2-654 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English